• Request a quote 951-735-3612

  • Clean & Clear Plus Filters

    November 28, 2016
  • Clean & Clear® Plus

    Cartridge Filters

    hayward filter

    Fiberglass Reinforced Polypropylene Tank

    Clean & Clear Plus Filters have a corrosion resistant injection molded filter tank featuring superior strength and reliability. The cartridge assembly uses four easy to clean, non-woven, polyester cartridges. Each filter is supplied with a bulkhead union set for easy installation.


    • NSF listed
    • Superior strength
    • Large filter area for increased dirt capacity
    • 1-1/2 in., 100% drain clean-out port
    • Continuous High Flow Internal Air Relief*
    • Injection molded tank
    • Balanced hydraulic flow
    • Tension Control Clamp
    • 100% factory tested
    • Black bulkhead unions
    • High Flow manual air relief valve
    Note: Actual system flow will depend on plumbing size and other system components.
    Note: Pentair Aquatic Systems does not recommend flow rates above 150 GPM.
    *Integrated Continuous High Flow Internal Air Relief is operational only when there is unobstructed flow in the circulating system.
    Operating Limits – maximum continual operating pressure of 50 PSI. Pool.spa (bather) applications, maximum operating water temperature (internal filter) 104 degrees F (40 degrees C).


    pentair pool.com
    Crystal Clear Water the easy Way
    The Clean & Clear Plus filter combines top-end filter performance
    with low maintenance. This dependable design uses special filter
    elements to strip tiny particles from your pool water…particles as
    small as 20 microns (an average grain of beach sand is 1,000
    microns). Our four-cartridge design provides maximum filter surface
    area to capture more dirt and extend time between cleanings. And
    cleaning is a snap—open the top, remove the cartridges, hose them
    off and the Clean & Clear Plus filter is ready to go again.
    We’ve maximized cartridge surface consistency to block and trap
    the maximum amount of solids, plus we use the most durable
    materials to extend cartridge life. The Clean & Clear Plus filter
    delivers commercial-grade performance that keeps pools clean
    and sparkling, day in and day out.
    Four-cartridge design traps more dirt and extends time
    between cleanings.
    Cartridges are easy to remove and rinse.
    Clamp ring allows easier access to cartridges and internal
    parts to speed service routines.
    1½” drain is easy to access and located to ensure
    complete draining during winterization.
    Fiberglass-reinforced polypropylene tank is strong and
    corrosion resistant for extra long life.


    The Eco Select brand identifies our“greenest” and
    most efficient equipment choices. Water flows very
    efficiently through the Clean & Clear Plus filter,
    often allowing the use of smaller pumps or lower
    pump speeds to minimize energy use. And when
    you rinse cartridges rather than backwash, you
    can significantly reduce water use, too
error: Content is protected !!